Before & After Photos

A concrete floor was sinking in a Festus, MO basement, causing a gap to form between it and the walls. To solve this issue the PolyLevel System was installed. This will stabilize, lift, and level the concrete slabs with high-strength polyurethane foam. This is a unique approach to repairing sinking concrete.  After drilling small holes into the concrete, a polymer foam is injected into the concrete slab to stabilize the surface. This installation technique allows the foam to expand as it cures, precisely lifting the slabs back up. This will prevent future problems from occurring and restore peace of mind for years to come!

A driveway in Festus, Missouri, had some cracking and slab displacement that needed to be addressed. Woods came out and installed a few products to address this issue. Their first install, the PolyLevel System, will make the slabs level again. This system consists of a highly durable foam that is injected directly beneath the concrete. As it sets, the foam lifts the concrete back up to its original position. With the displacement corrected, it was time for Woods to address the cracks using the NexusPro System. This system is a silicone-based sealant for cracks. It is specially engineered to stay flexible over time and stand up to harsh weather conditions. It has a very quick application and drying time and can last over 20 years. With these two installs in place, this driveway is practically as good as new!

In the before photo you can see that the pathway from the front door to the driveway was starting to sink, tilting away from the house. If you look closely at the step up to the house you can see the difference in where the sidewalk should be compared to where it is in the photo. Woods' PolyLEVEL foam injection lifted these concrete slabs back to their original position, and will permanently keep them there. PolyLEVEL foam causes minimal down time as these homeowners were able to walk on this pathway just 15 minutes after completion of the project! 

Homeowner Dianna S. in Arnold, MO noticed unleveled and cracked concrete in the driveway of her home. After realizing the unpleasant appearance and safety hazards that comes with uneven concrete, she gave Woods Basement Systems a call. 

System design specialist, Jeremy R. did an inspection and created a design that would restore the driveway of the home. Foreman William T. did a PolyLEVEL installation that would guarantee leveled and safe concrete. The PolyLEVEL system requires lightweight equipment and less damage than other repair options. Instead of using a mixture of concrete and mud, high-density polymers are injected into small holes that are drilled in the concrete.

As the "after" picture shows, the PolyLEVEL system was the best solution to restore the driveway of the home. 

Chris H was concerned about the uneven concrete in front of his home. So, he decided to call Woods Basement Systems. System Design Specialist David D was able to come up with a solution to the problem.

Foreman William T used PolyLevel to raise the sinking concrete. PolyLevel is injected into the concrete and will push it upward. The injection will leave behind a dime sized hole that will be filled in with concrete.