Find your expert.
Fix your problem.
Breathe easy.
It only takes a few seconds.
Before & After Photos
Click on a photo to enlarge.
Concrete Repair in Somerset, Kentucky
This front porch was sunken into the ground by a couple inches, allowing dirt to wash up and other cosmetic issues. We sprayed PolyLevel foam under the concrete to raise the porch back up as well as seal it from rain.
Sunken Concrete Raised in Richmond, Kentucky
This porch was sinking away from the home, causing the porch to crack between the door and the porch slab. This can happen when the soil shifts from underneath the porch, as was the case here We raised the porch slab back to a normal level using our PolyLeveling foam. We then sealed the crack with NexusPro sealant, which will keep water and debris out of the crack.
Polylevel Injection used to raise sidewalk in Pine Knot, KY
We used Polylevel Injection to repair the driveway slab that had sunk.
Concrete Repair Contractor in Berea, Kentucky
For this school in Berea, KY, we leveled out the concrete slabs surrounding the front entrance. We receive many calls for public areas with high walking-traffic volume because these places can be held liable if someone trips and hurts themselves. We made sure to level out all the tripping hazards for this school with our PolyLevel foam jacking. After we leveled everything out, the administrators were relieved that they spent part of their spending budget wisely with The Basement Doctor. Not only are the slabs even now, but they will still that way for a long, long time.
Sidewalk Resurfacing for Public Library in Berea, Kentucky
This public library in Berea, KY, had a sidewalk with a tripping hazard. This sidewalk slab had sunken about 2 inches down and away from the adjacent patio slab, a pretty big liability for a public library with lots of foot traffic. We first lifted the slab closest to the patio slab to close out the gap between the two, and then we leveled out the rest of the sidewalk slabs so that every slab is level with one another. After leveling, we then sealed the joints with our NexusPro joint sealant. Our PolyLevel only takes ten minutes to cure, so the public got right back to being able to use this access door.