Before & After Photos

It's important to have a functioning sump pump in your home to ensure it is protected against water intrusion. We installed our TripleSafe Sump Pump System for this homeowner in New City, NJ. TripleSafe provides three levels of protection against water intrusion and will effectively pump water away from the basement.

A New City, NY homeowner noticed their concrete patio was sinking and becoming unlevel, which could cause ongoing tripping hazards, so they contacted us for a solution. Our System Design Specialist, Jeff, thoroughly inspected the concrete and recommended the Polylevel Injections as the best solution. PolyLevel consists of a foam injected underneath the slab and lifted as close to its original height as possible. When rain pours, the foam does not disintegrate, preventing the concrete from sinking again! Now, the homeowner can enjoy their patio for the summer without worrying about tripping hazards!

This sidewalk was sinking outside of an office building in Ridgefield, NJ. The building owner contacted Quality 1st Basement Systems to discuss the options he had. The design Specalist went to Ridgfield and did a full inspection of the entire sidewalk around the building. He noticed that there was only a select few concrete slabs that needed lifting. Qualty 1st foreman and his crew was able to pump 363 pounds total of PolyLevel  into the sidewalks to raise them back to the desired level.

The concrete area connected to the front walkway had settled near the front steps and foundation of the home. Concrete Repair Specialist, Jeff Pitek, worked with our team to provide a permanent solution to these homeowners concrete concerns. 

Our team recommended PolyLevel, a lightweight and waterproof polyurethane foam that lifts and levels the concrete back towards its original position. 

Check out how our team raised this sinking and settling front walkway. They drilled small penny-sized holes into each concrete slab. Next, using special equipment, PolyLevel was injected underneath the slab, raising it back to level. Once the slab is raised, PolyLevel hardens to stabilize the slab to prevent future settlement.