Before & After Photos

After a homeowner began noticing the floors on their first floor were sagging they contacted their local experts, Quality 1st Basement Systems to get an estimate on sagging floor repair. We sent Foundation Specialist, Jack Huber, out to inspect the floors and the basement beams to ensure there was enough support. 

Upon inspection he realized the sagging floors were due to lack of support to the basement beams and floor joist. He recommended our SmartJack Stabilizer System to provide the support the beams needed. Each SmartJack is installed underneath the sagging beam and properly adjusted to allow gradual movement back towards its original position. 

A Ringwood, New Jersey homeowner noticed their basement walls were bowing inwards, so they contacted Quality 1st Basement Systems for a solution. We installed the CarbonArmor Wall Reinforcement System to stabilize the walls and prevent them from bowing further. Next, we removed the old existing sump pump system and replaced it with our WaterGuard and TripleSafe Sump pump. Now that this basement has a full perimeter system and our Wall Reinforcement System, this Basement is 100 percent protected! 

Pompton Lakes, NJ homeowner contacted Quality 1st Basement Systems after noticing their garage walls started bowing inwards. They were concerns that over time this would cause serious foundation issues and so they needed a system that would stabilize the walls. Foundation Repair Specialist, Mike Fiorillo, recommended our PowerBrace Foundation Wall Repair System.  The system is installed with steel beams that are secured to the joists above the wall with a strong steel bracket. A benefit of this system is the adjustability to tighten each brace need be. 

The existing columns in this basement could no longer support the weight of the home. Our Senior Design Specialist, Jeff N. designed a solution that would add additional support the foundation needed for this home to be stable and therefore safe. Esau, our Foreman and his team were in charge of this project to make sure the installation was completed on time. By successfully installing our SmartJack Stabilizers, the homeowner no longer has to worry about sagging floors and weakened columns.

This homeowner in Millburn, New Jersey noticed their basement wall was bowing inwards. The homeowner contacted Quality 1st Basement Systems, and our System Design Specialist Joe Hubbard provided an inspection and suggested they use a wall reinforcement system. Our crew installed our CarbonArmor Wall Reinforcement System, which is made from a fiber-reinforced polymer that is 10 times stronger than steel. The straps are attached to the wall and secured with heavy-duty steel brackets. The straps will stabilize the wall and begin to pull it back to its original position. The homeowner was happy with the results and they did not have to worry about their foundation walls!