Before & After Photos

While these photos may not seem like this basement was in that bad of condition, a case study that was also done on this home will show you a much different story. Areas in this basement were starting to crumble because of how much water had been coming in and damaging the area. The sump pump that we installed will certainly help keep this area from flooding and causing problems.

The "before" picture shows an area that had been severely damaged by all of the water that had come through over the years. Interestingly enough, even though the homeowner had a sump pump, the damage and issues were not taken care of. This is because in most cases the problems won't go away just because there is a sump pump. The water can still raise the relative humidity level and begin to grow mold.

The "after" picture looks almost like a different home. The work that our crew was able to do in this basement was incredible. While the main focus of this post is the TripleSafe sump pump, you can also see the CleanSpace and the ThermalDry Flooring that we installed, both products that help to keep the water from staying in the basement. However, the TripleSafe is the best sump pump system that we have, and is called the TripleSafe because of its three separate pumps. One of these pumps runs on the DC power provided by the battery back-up, which you can also see in the after picture.

Basements can be dark, scary, and wet places, but they don't always have to be! Basements are much more likely to be affected by water intrusion because they are below grade and water can get into the basement through the floors and walls much easier. This can began to cause serious damage to different areas of the basement and be detrimental to the health of the home and any occupants. 

The "before" picture shows what the crawlspace looked like when our System Design Specialist went out to the home to figure out what could be done to help this homeowner out. The photo gives a pretty good look at the condition of the basement in general. However in this photo there is quite a bit of water that has soaked into the floor near the back wall. This is a pretty clear indication of water intrusion, so our Specialist knew exactly what to do.

The "after" photo shows off the basement once the crew had began working on it. At this point in the installation process, three main products have been installed; WaterGuard, CleanSpace Liner, and ThermalDry. The CleanSpace liner is the white liner that can be seen going around the bottom of the wall, this helps to catch water and drain it to the WaterGuard. The WaterGuard then drains the water straight to the sump pump which pumps out the water. The last product that can be seen is the ThermalDry floor. This isn't a product we use too often, but it helps to serve as insulation for the floor. 

WaterGuard is one of the most popular products that we install in basements and this home was no different. This homeowner noticed water getting into his finished basement when it would rain. In order to keep his finished basement beautiful and usable, he needed to have WaterGuard and a sump pump installed. In the end, he decided on two sump pumps (a SuperSump and an UltraSump), as well as over 30 feet of WaterGuard. The area near the bathroom was the main culprit of the water intrusion, so that's where a lot of the WaterGuard and a sump pump was installed.

The "before" picture shows off where the toilet usually sits. However, because there would be WaterGuard installed here, it needed to be taken out. However, even though this may be bothersome, in the long run, it is immensely beneficial.

The "after" photo shows what the area looked like after we had installed the WaterGuard. It may not be the prettiest of sights at the moment, but the good thing is that more tile can be laid. However, if this customer didn't fix this issue right away, they could have had several thousand dollars in damage, and the problem still would not have been fixed.

This homeowner was concerned about their basement when they started noticing more and more water coming in through one of the walls. Fortunately, the homeowner caught on to this issue before it did any real damage. They actually had heard about us from a friend, and gave us a call to come visit them! Our Systems Design Specialist proposed for a SuperSump pump system and around 40 feet of WaterGuard be installed.

The "before" photo gives a quick look at part of the basement in question. As you can see, there was not too much damage from the water at this point. But this homeowner knew that eventually it would, so they erred on the side of caution and went ahead and got it installed before the damage was done, rather than afterwards.

The "after" picture shows the same area, but after the WaterGuard had been installed. As you can see, it doesn't look like much work was done, but this homeowner didn't need to worry about water getting through this area any more. The WaterGuard is completely hidden by the floor, except for a small gap between the floor and wall of the basement.

Water intrusion is a bad thing no matter where it happens in a home. This home happened to have this problem in their finished basement. If left unchecked, water intrusion can do some major damage including rot and mold. This can be especially bad when these things actually happen in the home, like this customer's case. Fortunately for them, they had not let it get to the point of rot or mold. They were more preemptive in this case and called us before too much damage was done.

The "before" photo shows the area just before we installed our products. We have to cut out and remove the drywall partially up the wall in order to install our CleanSpace Wall, which helps to direct and drain water to our Waterguard drain that we also installed.

The "after" picture shows what the (almost) finished product looks like. You can see the area behind the insulation that has been covered with the CleanSpace liner that was just mentioned. The dark area of concrete is where the Waterguard was installed. It drains down to the sump pump where any collected water is then pumped out of the basement.