Before & After Photos

Our WaterGuard piping system is the best in the business. There are no “ifs”, “ands”, or “buts” about it. Unlike other systems that require you to either dig up your lawn or allow large bulking pipes to roll around your property, our WaterGuard system remains unseen. But, don’t take my word for it; let’s take a look at the examples below.

See the “before” photo? When these Horse Shoe, North Carolina homeowners called into All-Dry of the Carolinas, their basement walls were leaking. Once the water dried, it would leave behind the whitish substance you see here—the efflorescence.  Both the floor and the wall suffer from this issue. Not only is it annoying, but it isn’t particularly beautiful in the least. It needed a prompt solution. The best way to deal with this is to install WaterGuard.

In the “after” photo, we’ve done just that. See that dark strip across the floor? That is where we’ve made the incision for the WaterGuard piping system. It’s a drain system that does not sit in the dirt. In fact, we install it right inside of the basement, against the wall. At that position, it catches all of the water that drains from the walls; however, it does not allow in any debris or dirt. It’s perfect. And, after the water dries, it will be practically invisible.

While we deal with water intrusion and waterproofing issues on a daily basis, however something that we don't get to see nearly as often is when a basement is actually flooded. This is pretty much the worst case scenario of a home with a basement, but it is still something that we are able to take care of. Our system is able to handle a significant amount of water, even more so than this homeowner had experienced.

This photo does not quite do this situation justice with the amount of water that got into the basement. The main source of water intrusion was through this basement door that didn't really have any way of preventing water from getting in. When there would be heavy rains, the water would run down to the lowest area (the door) and would begin to slowly make its way into the home. The homeowners realized how big of an issue that this was and wished to get it taken care of as soon as possible!

Fortunately we have seen and waterproofed basements that were similar to this one and some that were even worse off. So when this homeowner came to us to see if we could help, we knew that we could. The product that has been installed in the photo is TrenchDrain, which is integrated into the WaterGuard  system in areas that are prone to more water flowing over it (i.e. doorways). Now any water that makes it past the door is immediately captured by the drain and taken off to the sump pump!

The ways that homes are built are not always helpful in keeping the crawlspace or basement dry. This is one reason why so many people require our services. This particular basement was having a lot of water intrusion through the walls of the basement. Since the homeowner was looking to make the area a more livable and usable space, they wanted this problem to be taken care of for good.

The "before" photo shows what the area looked like before our crew came out to install our products. The most obvious sign that this homeowner needed this system, in this photo, are all of the watermarks on the bottom of the wall. The white marks are minerals that are left behind when the water evaporates. This is never a good sign, and was part of the reason that the homeowner was concerned in the first place.

The "after" picture is a much different story than the first photo. You can see all three of the main products that were installed in the basement. The most obvious one is probably the CleanSpace Wall, which is the white liner that goes around the bottom few feet of the wall. This helps to drain the water to the WaterGuard. The WaterGuard is a drain that runs around the perimeter of the basement and collects the water that comes through the wall. The water then drains through the WaterGuard to the SuperSump pump system, where it is then pumped outside and away from the home. These three products do such a great job in keeping basements dry, and are usually pretty simple and easy to install.

Any air from the outside can ruin the humidity within the inside of your crawlspace. Once the air mixes, the perfect temperature you’ve strived to maintain slips away. And, just having a door to a crawlspace does nothing. Anyone can have a door. In fact, most crawlspaces do have them, but many of them are made out of wood and are not properly sealed. Air, as you know, can slip in through any skinny opening without much trouble at all. That’s where we come into play.

The original crawlspace door was much like the ones I described above. It was wooden, held closed only with a small strap. For short term use, it was fine. However, these doors are not something you should get used to having.  Wooden doors have a tough job being so close to the ground. They warp, rot, and are impossible to keep painted. With the warping and the rotting, the door changes shape. It no longer correctly seals the crawlspace at all (if it ever did).

That’s not the case with our EverLast door. It’s ½ inch thick, solid plastic, so it will never rot or need paint. It has a weatherseal, so it doesn’t allow even a small gust of air into the crawlspace.

The problem with block walls is simple: they’re porous. They allow water right into your basement. Once the water gets in, there is simply no way to prevent it from staining your floor. Take a look at our “before” photo. See those dark spots along the floor and wall? That is where water has come and gone. As long as there is rain, the water will continue to creep in and pool—unless it’s stopped. That is where we come into play.

In the “after” photo, All-Dry of the Carolinas has installed our solution. We made an incision along the perimeter of the wall to capture the water that comes through it. The WaterGuard piping system then directs the water into the SuperSump pump. The pump then directs the water out of the basement.

Water problem solved.