Before & After Photos

Here is a photo of the state of this homeowner's crawlspace when our design specialist, Corey, first did his initial inspection and estimate. Its your typical messy crawlspace with a moist ground floor. This moisture was playing a large part in the sinking floor problem the homeowner reached out to us about. In the second image, you can see the crawlspace after Corey designed a system for the home and one of our talented production crews made it a reality. The mess is gone, and more importantly, the moisture will no longer be a problem. The white CleanSpace liner you see all throughout the crawlspace is acting as a barrier,  keeping out ground water seepage. Unseen in the images, is our energy efficient crawlspace dehumidifier and our perimeter drainage system. Both working alongside the CleanSpace vapor barrier to stop moisture, water, and humidity from affecting this home.

Though they may look much different now, these two images were taken in the same crawl space in Forest, MS. The drastic change is due to our encapsulation system, a moisture-proofing system this home was in desperate need of. The homeowners originally called us about buckling floors, a side effect of crawl space moisture that only gets worse over time. At one point they had tried to combat this with the vapor barrier you see in the first image, but this clearly wasn't cutting it. In the after-image, you can see its upgrade, the CleanSpace Liner. This liner is much more durable AND covers much more of the crawl space. This solution works together with our crawl space dehumidifier and sump pump system to create a regulated space that keeps itself dry from many forms of moisture. Buckling floors are no longer a worry!

Mold and moisture plaguing the crawlspace prompted this homeowner to give us a call. The home is 1900 square feet of crawlspace. He knew his problem would only get worse if he didn't address it immediately. With previous knowledge of our encapsulation system, he knew he was calling the right people. Ransom Ford inspected the crawlspace and found it was something we could easily rectify. 

We sealed off the vents and openings, installed a sump pump in the lowest spot, lined it with our 20 mil liner, and finally placed a dehumidifier inside the crawlspace to regulate the humidity. Now his home is moisture free and it would be impossible for mold to grow on his joists with our system. 

It is hard to believe that these two images were taken inside the same crawl space. It once contained moisture, fallen insulation, and trash, but now all of that has been replaced by our Encapsulation System! Visually the difference is striking, but even more important, the level of moisture control is much different as well. Our CleanSpace Liner is covering the ground, supports, and walls of the crawl space to act as a barrier against moisture, while our crawl space dehumidifier and sump pump system are in place to regulate humidity and send away collected water. We're proud of the difference our team was able to make!

At a height of right over two feet, this crawlspace was holding moisture due to visqueen being put over the ground. This plastic, because it's not sealed off and air tight, ends up hurting the crawlspace more than helping it. It traps water under the plastic and creates musty smells that may not have been there before. Melissa Johnson inspected this crawlspace and proposed our well tested solution. We were able to remove the visqueen and apply our encapsulation system to the crawlspace. We do this by cleaning out the crawlspace, installing a sump pump, drainage matting, CleanSpace liner on top of the matting and sealing it off around each wall of the crawlspace, and putting a dehumidifier in on top of it. These products work together to keep moisture out and dry air in.